Photovoltaic panels connected in parallel for power generation

Thus the effect of parallel wiring is that the voltage stays the same while the amperage adds up. Photovoltaic solar panels generate a current when exposed to sunlight (irradiance) and we can increase the current output of an array by connecting the pv panels in parallel.

Connecting solar panels in parallel is just the opposite of series connection and is used to increase the total output current of the array, and hence the total output power while keeping the same voltage. 'The same voltage' is the system voltage which for off-grid solar panels systems is usually as low as either 6V or 12V.

The following figure shows solar panels connected in parallel configuration. If the current IM1 is the maximum power point current of one module and IM2 is the maximum power point current of other module then the total current of the parallel-connected module will be IM1 + IM2.

When you connect solar panels in series, the total output current of the solar array is the same as the current passing through a single panel, while the total output voltage is a sum of the voltage drops on each solar panel. The latter is only valid provided that the panels connected are of the same type and power rating.

On the other hand, if our two solar panels have both different wattage and different voltage, then parallel connection is not possible, since the panel with the lowest voltage would behave like a load, and would begin to absorb current instead of producing it, with the relative consequences. What if we have one 12V panel and two 6V panels?

As we have seen throughout theses alternative energy tutorials, photovoltaic solar panels are semiconductor devices that covert sunlight into electrical DC energy. Connecting PV panels together in parallel increases current and therefore power output, as electrical power in watts equals “volts times amperes” (P = V x I).